Mini OSD Module For APM Flight Controller

This OSD is automatically recognized by the camera video system. However, if you do not connect the camera, you can have a solder joint on the back to select the system without the camera output. The default is N, the PAL is soldered to the PAL output.MinimOSD is an OSD based on Arduino. Designed for flight control of the ArduPilot MEGA and MAVlink protocols. Its main components are an Arduino ATmega328 MCU and a MAX7456 monochrome screen overlay chip. Programming is via a FTDI compatible 6 pin connector. It features two separate power and ground sections for the isolation phase of the OSD function: a 5V section of the ATMEGA and the digital phase of the OSD function, powered by a FTDI cable or other 5 V source; and a regulated 5 The analog phase of V’s OSD function is capable of handling up to +12 V input power through a video/output connector. The welding jumper, power supply and ground are combined, if needed.

Features:

• Size: 39mm x 19mm (without pin header)
• Weight: 6g (without cable)

Note:

This osd can only be used in APM pirates and other flight controllers that support the mavlink protocol. It cannot be used separately for gps, and can only read the mavlink protocol.
If it is used alone, please connect TX RX to APM.
If it is connected with the digital transmission, the TX definition of the OSD is not connected, and the RX can be directly.
If you need to modify the OSD parameters, please bring your own or purchase FTDI.