dsPIC30F2010 20MHz 16-bit Microcontroller ICs

The Microchips dsPIC30F family of Digital Signal Controllers (DSCs) offer designers DSP like performance with the simplicity of an MCU. The dsPIC30F1010/202x range of devices feature peripherals to support digital switch-mode power supplies (SMPS) and other digital power conversion applications. dsPIC30F Motor Control 16-bit Digital Signal Controller. Seamless migration options from this device to dsPIC33F, PIC24H or PIC24F devices in similar packages.

Features:

1. High-Performance dsPIC30F core
2. Modified Harvard architecture
3. C compiler optimized instruction set architecture
4. 24-bit wide instructions, 16-bit wide data path
5. Up to 30 MIPS operation
6. DSP Engine for math intensive operations
7. Modulo and Bit-Reversed Addressing modes
8. Two 40-bit wide accumulators with optional saturation logic
9. 17-bit x 17-bit single cycle hardware fractional/ integer multiplier
10. Single cycle Multiply-Accumulate (MAC) operation
11. 40-stage Barrel Shifter
12. Dual data fetch

Operating Conditions:

1. Wide operating voltage range (2.5V to 5.5V)
2. Industrial and Extended temperature ranges

Peripheral Features:

1. High current sink/source I/O pins: 25 mA/25 mA
2. Optionally pair up 16-bit timers into 32-bit timer modules
3. 3-wire SPI™ modules (supports 4 Frame modes)
4. I2C™ module supports Multi-Master/Slave mode and 7-bit/10-bit addressing
5. Addressable UART modules with FIFO buffers

Motor Control PWM Module Features:

1. Motor Control PWM Module with Complementary or Independent Output modes
2. Edge and Center Aligned modes
3. Multiple duty cycle generators
4. Dedicated time base with 4 modes
5. Programmable output polarity
6. Dead time control for Complementary mode
7. Manual output control
8. Trigger for synchronized A/D conversions

Quadrature Encoder Interface Module Features:

1. QEI with Phase A, Phase B and Index Pulse input
2. 16-bit up/down position counter
3. Count direction status
4. Position Measurement (x2 and x4) mode
5. Programmable digital noise filters on inputs
6. Alternate 16-bit Timer/Counter mode
7. Interrupt on position counter rollover/underflow

Analog Features:

1. 10-bit 1 Msps Analog-to-Digital Converter (A/D)
2. A/D Conversion available during Sleep and Idle
3. 4 Sample/Hold Channels
4. Multiple Conversion Sequencing Options

Special Microcontroller Features:

1. Enhanced Flash program memory with 10,000 erase/write cycle (min.) for industrial temperature range, 100K (typical)
2. Data EEPROM memory with 100,000 erase/write cycle (min.) for industrial temperature range, 1M (typical)
3. Self-reprogrammable under software control
4. Power-on Reset (POR), Power-up Timer (PWRT) and Oscillator Start-up Timer (OST)
5. Flexible Watchdog Timer (WDT) with on-chip low power RC oscillator for reliable operation
6. Fail-Safe clock monitor operation
7. Detects clock failure and switches to on-chip low power RC oscillator
8. Programmable code protection
9. In-Circuit Serial Programming™ (ICSP™)
10. DC to 40 MHz external clock input
11. 4 MHz-10 MHz oscillator input with PLL active (4x, 8x, 16x)
12. Programmable Brown-out Detection and Reset generation
13. Sleep, Idle and Alternate Clock modes for power management

Packing List:

1Pc * dsPIC30F2010 20MHz 16-bit Microcontroller ICs